RouterEntry · Sources checked · How we write our guides
This follows Telos Alliance's Altus SE System Management documentation. The AoIP LAN1 default is 192.168.2.100; WAN LAN2 defaults to DHCP. Use the current assigned address if the installation has changed either interface.
On the Altus SE's authorized local network, enter 192.168.2.100:8085 in your browser's address bar only if 192.168.2.100 is its current address.
Use username user and the current management password set during setup. Initial user / user belongs to first-use setup, which requires a unique password. Stop if that setup prompt appears. The source specifies port 8085 without a browser scheme.
Read System status
On System, read Version Information for the active firmware bank and its software version. System Status shows CPU, memory, Ethernet utilization and available disk space. Leave bank selection and configuration unchanged.
If access fails
Confirm the current interface address, port 8085 and installed management password with the administrator. LAN1 can be reconfigured, and LAN2 defaults to DHCP. Do not reboot, change banks, reset the system or enable remote support to view this information.
Browse documented IP addresses · Find your exact equipment · Choose a troubleshooting path
Telos Alliance Altus SE Quick Start Guide Telos Alliance Altus SE System Management Menu